Skip to making music
  1. Step 1: Balance, you are here
  2. Step 2: Polish
  3. Step 3: Save

Play what Sequence plays and listen: can you hear every part? Then balance them.

Listen

Your song has no sections yet, so Play plays what Sequence plays. Send parts to the Song tab to mix the whole song.

Stopped. Space plays and stops when the focus is not on a control.

Judge the mix

Three ways to check the balance of what Sequence plays. None of them changes your notes.

Turns parts down until they sound about equally loud. Measured from the song, so melodies count too. Never pushes a fader above 0 dB.

Shows where each part sits from low to high, and where parts crowd each other. It points things out; you decide.

Says every part's level out loud as it plays. Stopped, it reads the measured loudness instead.

Next

When the balance sounds right, master the song (a last polish you can hear before and after) and save it as a file.

Mixer

One strip per part: its level, where it sits left to right, its tone, mute and solo. The last strip is the whole song's level. Changes are heard straight away and are what the saved file uses.

0 parts
No tracks yet. Add sounds to your kit and they'll appear here as mixer channels.

How loud each part is

Measured from what Sequence plays with every fader at 0 dB, so it shows the parts themselves, not where the faders are. About 10 decibels quieter sounds roughly half as loud.

Not measured yet. Measuring plays each part on its own, silently and faster than real time, and takes a few seconds.